Mounting Arm Bolt M4 x 20mm
Mounting Arm Bolt M4 x 20mm
Mounting Arm Bolt M4 x 20mm
Mounting Arm Bolt M4 x 20mm

Mounting Arm Bolt M4 x 20mm

SHCS-M4-20

Regular price $0.25
/
Shipping calculated at checkout.

M4 x 20mm long Socket Head Cap Screw Stainless to be used with our mounting arm.

  • M4 x 20mm SHCS
  • Stainless Steel
  • M3 Hex tool

Instructions

Mounting Arm

  • Mount onto the handle bar to the left or right of the stem and tighten with a 3mm Hex wrench.
  • Torque not to exceed 1.6Nm/14inlbs.

Adapters

  • Remove the bolt and washer from the adapter and install into the mounting arm slot.
  • Thread on the adapter with the washer on the opposite side flush against the bolt head.
  • Torque to no more than 1.6Nm/14inlbs using a Hex wrench.
  • Apply a small amount of Blue LOCTITE® #242 to the threads of the adapter bolt if needed to keep it from coming loose.

Carbon Fiber Stem Mount

  • Replace the stem’s screws (the bottom left and right), by inserting the spacer first, then the mount, washer and finally the long black Titanium screws.
  • Don’t use excessive force it may break the product and void the warranty.
  • Tighten the screws using the torque suggested by your stem manufacturer approx. 2 to 3Nm and lube the bolt with anti-seize grease.
  • Check holes for alignment between front clamp & stem. If there is an alignment mismatch top to bottom, the screw can undergo abnormal stresses and could break.
  • Before tightening make sure that the titanium screw penetrates the stem with full thread engagement. If screws don’t fully engage, please contact us.