The Mounting Arm allows you to mount One or Two devices Out front and Center on a Mountain or Road bike. It allows you to Slide and Rotate them to face forwards, backwards, right side up or upside down. Mount any combination of a camera, cycling computer, phone and light. Just one mount needed for all your electronic devices.
Works with all our adapters to mount Cycling Computers, Lights, Action Cameras and Sport watches
Mount up to Two devices on one Mounting Arm
Mount your devices out-front or behind the bars
Rotate and slide your devices to multiple positions
Free up bar space with only one mount for all your devices
Buy only one mount and save money
No need to buy new mounts for new devices
Strong, light, and shock absorbing
Fits all 31.8mm diameter bars
Torque not to exceed 1.6Nm/14inlbs
Made from a CARBON composite Nylon Weight 28g Designed, engineered, and manufactured in the U.S.A
Mount onto the handle bar to the left or right of the stem and tighten with a 3mm Hex wrench.
Torque not to exceed 1.6Nm/14inlbs.
Remove the bolt and washer from the adapter and install into the mounting arm slot.
Thread on the adapter with the washer on the opposite side flush against the bolt head.
Torque to no more than 1.6Nm/14inlbs using a Hex wrench.
Apply a small amount of Blue LOCTITE® #242 to the threads of the adapter bolt if needed to keep it from coming loose.
Carbon Fiber Stem Mount
Replace the stem’s screws (the bottom left and right), by inserting the spacer first, then the mount, washer and finally the long black Titanium screws.
Don’t use excessive force it may break the product and void the warranty.
Tighten the screws using the torque suggested by your stem manufacturer approx. 2 to 3Nm and lube the bolt with anti-seize grease.
Check holes for alignment between front clamp & stem. If there is an alignment mismatch top to bottom, the screw can undergo abnormal stresses and could break.
Before tightening make sure that the titanium screw penetrates the stem with full thread engagement. If screws don’t fully engage, please contact us.