Watch & Light Mount
Watch & Light Mount

Watch & Light Mount

AS-UU10G

Regular price $40.00
/
Shipping calculated at checkout.

Mount your Watch and Light Out front and Center using our mounting arm and two universal adapters. Slide and Rotate the Watch to the Optimum Viewing Angle and position your Light lower to the ground for improved lighting.

    Works with any Performance watch like Polar®, Garmin®, Fitbit®, Sunnuto®, Apple® that mounts to a 31.8mm bar.

    Mounting Arm

    • Mount up to Two devices on one Mounting Arm
    • Mount your devices out-front or behind the bars
    • Rotate and slide your devices to multiple positions
    • Free up bar space with only one mount for all your devices
    • Buy only one mount and save money
    • No need to buy new mounts for new devices
    • Strong, light, and shock absorbing
    • Fits all 31.8mm diameter bars
    • Torque not to exceed 1.6Nm/14inlbs

    Universal Adapter

    • Mount any 31.8mm bar mountable device on the Universal Adapter
    • Mount a Light Out front, Center and lower to the ground for improved lighting
    • Mount your Cycling Computer Out front
    • Torque not to exceed 1.6Nm/14inlbs
    Made from a CARBON composite Nylon
    Weight 64g
    Designed, engineered and manufactured in the U.S.A

    Instructions

    Mounting Arm

    • Mount onto the handle bar to the left or right of the stem and tighten with a 3mm Hex wrench.
    • Torque not to exceed 1.6Nm/14inlbs.

    Adapters

    • Remove the bolt and washer from the adapter and install into the mounting arm slot.
    • Thread on the adapter with the washer on the opposite side flush against the bolt head.
    • Torque to no more than 1.6Nm/14inlbs using a Hex wrench.
    • Apply a small amount of Blue LOCTITE® #242 to the threads of the adapter bolt if needed to keep it from coming loose.

    Carbon Fiber Stem Mount

    • Replace the stem’s screws (the bottom left and right), by inserting the spacer first, then the mount, washer and finally the long black Titanium screws.
    • Don’t use excessive force it may break the product and void the warranty.
    • Tighten the screws using the torque suggested by your stem manufacturer approx. 2 to 3Nm and lube the bolt with anti-seize grease.
    • Check holes for alignment between front clamp & stem. If there is an alignment mismatch top to bottom, the screw can undergo abnormal stresses and could break.
    • Before tightening make sure that the titanium screw penetrates the stem with full thread engagement. If screws don’t fully engage, please contact us.