Mount your Cycling Computer and Light Out front and Center using just One mounting arm. Slide and Rotate the Computer to the Optimum Viewing Angle and position your Light lower to the ground for improved lighting.
Works with WAHOO® Element Roam and Element Bolt series computers.
Mounting Arm
Mount up to Two devices on one Mounting Arm
Mount your devices out-front or behind the bars
Rotate and slide your devices to multiple positions
Free up bar space with only one mount for all your devices
Buy only one mount and save money
No need to buy new mounts for new devices
Strong, light, and shock absorbing
Fits all 31.8mm diameter bars
Torque not to exceed 1.6Nm/12inlbs
Cycling Computer Adapter
Works with WAHOO® Element Roam and Element Bolt series computers.
Slide and Rotate: Slide and Rotate your computer to most positions.
Eliminate Glare: Rotate your computer to Eliminate Glare.
Optimize the Viewing Angle: Rotate and Slide the computer to your Optimum-Viewing Angle.
Torque not to exceed 1.6Nm/14inlbs
Universal Adapter
Mount any 31.8mm bar mountable device on the Universal Adapter
Mount a Light Out front, Center and lower to the ground for improved lighting
Mount your Cycling Computer Out front
Torque not to exceed 1.6Nm/14inlbs
Made from a Carbon composite Nylon and Composite nylon
Weight 52g
Designed, engineered and manufactured in the U.S.A
Instructions
Mounting Arm
Mount onto the handle bar to the left or right of the stem and tighten with a 3mm Hex wrench.
Torque not to exceed 1.6Nm/14inlbs.
Adapters
Remove the bolt and washer from the adapter and install into the mounting arm slot.
Thread on the adapter with the washer on the opposite side flush against the bolt head.
Torque to no more than 1.6Nm/14inlbs using a Hex wrench.
Apply a small amount of Blue LOCTITE® #242 to the threads of the adapter bolt if needed to keep it from coming loose.
Carbon Fiber Stem Mount
Replace the stem’s screws (the bottom left and right), by inserting the spacer first, then the mount, washer and finally the long black Titanium screws.
Don’t use excessive force it may break the product and void the warranty.
Tighten the screws using the torque suggested by your stem manufacturer approx. 2 to 3Nm and lube the bolt with anti-seize grease.
Check holes for alignment between front clamp & stem. If there is an alignment mismatch top to bottom, the screw can undergo abnormal stresses and could break.
Before tightening make sure that the titanium screw penetrates the stem with full thread engagement. If screws don’t fully engage, please contact us.
