Wahoo Computer Mount
Wahoo Computer Mount
Wahoo Computer Mount
Wahoo Computer Mount
Wahoo Computer Mount
Wahoo Computer Mount
Wahoo Computer Mount
Wahoo Computer Mount
Wahoo Computer Mount
Wahoo Computer Mount
Wahoo Computer Mount

Wahoo Computer Mount

AS-W100O

Regular price $30.00
/
Shipping calculated at checkout.

Mount your Cycling Computer Out front and Center. Slide and Rotate to eliminate glare and optimize the viewing angle.

    Works with WAHOO® Element Roam and Element Bolt series computers.

      Mounting Arm

      • Mount up to Two devices on one Mounting Arm
      • Mount your devices out-front or behind the bars
      • Rotate and slide your devices to multiple positions
      • Free up bar space with only one mount for all your devices
      • Buy only one mount and save money
      • No need to buy new mounts for new devices
      • Strong, light, and shock absorbing
      • Fits all 31.8mm diameter bars
      • Torque not to exceed 1.6Nm/14inlbs
      • Made from a CARBON composite Nylon

      Cycling Computer Adapter

      • Works with WAHOO® Element Roam and Element Bolt series computers.
      • Slide and Rotate: Slide and Rotate your computer to most positions.
      • Eliminate Glare: Rotate your computer to Eliminate Glare.
      • Optimize the Viewing Angle: Rotate and Slide the computer to your Optimum-Viewing Angle.
      • Torque not to exceed 1.6Nm/14inlbs
      Made from a CARBON composite Nylon
      Weight 37g
      Designed, engineered, and manufactured in the U.S.A

      Instructions

      Mounting Arm

      • Mount onto the handle bar to the left or right of the stem and tighten with a 3mm Hex wrench.
      • Torque not to exceed 1.6Nm/14inlbs.

      Adapters

      • Remove the bolt and washer from the adapter and install into the mounting arm slot.
      • Thread on the adapter with the washer on the opposite side flush against the bolt head.
      • Torque to no more than 1.6Nm/14inlbs using a Hex wrench.
      • Apply a small amount of Blue LOCTITE® #242 to the threads of the adapter bolt if needed to keep it from coming loose.

      Carbon Fiber Stem Mount

      • Replace the stem’s screws (the bottom left and right), by inserting the spacer first, then the mount, washer and finally the long black Titanium screws.
      • Don’t use excessive force it may break the product and void the warranty.
      • Tighten the screws using the torque suggested by your stem manufacturer approx. 2 to 3Nm and lube the bolt with anti-seize grease.
      • Check holes for alignment between front clamp & stem. If there is an alignment mismatch top to bottom, the screw can undergo abnormal stresses and could break.
      • Before tightening make sure that the titanium screw penetrates the stem with full thread engagement. If screws don’t fully engage, please contact us.

      You may also like