Polar Computer Mount
Polar Computer Mount
Polar Computer Mount
Polar Computer Mount
Polar Computer Mount
Polar Computer Mount
Polar Computer Mount
Polar Computer Mount

Polar Computer Mount

AS-P100G

Regular price $30.00
/
Shipping calculated at checkout.

Mount your Cycling Computer Out front and Center. Slide and Rotate to eliminate glare and optimize the viewing angle.

    Works with POLAR® M460 and V650 series computers.

      Mounting Arm

      • Mount up to Two devices on one Mounting Arm
      • Mount your devices out-front or behind the bars
      • Rotate and slide your devices to multiple positions
      • Free up bar space with only one mount for all your devices
      • Buy only one mount and save money
      • No need to buy new mounts for new devices
      • Strong, light, and shock absorbing
      • Fits all 31.8mm diameter bars
      • Torque not to exceed 1.6Nm/14inlbs

      Cycling Computer Adapter

      • Works with POLAR® M460 and V650 series computers.
      • Slide and Rotate: Slide and Rotate your computer to most positions.
      • Eliminate Glare: Rotate your computer to Eliminate Glare.
      • Optimize the Viewing Angle: Rotate and Slide the computer to your Optimum-Viewing Angle.
      • Torque not to exceed 1.6Nm/14inlbs
      Made from a CARBON composite Nylon
      Weight 37g
      Designed, engineered, and manufactured in the U.S.A

      Instructions

      Mounting Arm

      • Mount onto the handle bar to the left or right of the stem and tighten with a 3mm Hex wrench.
      • Torque not to exceed 1.6Nm/14inlbs.

      Adapters

      • Remove the bolt and washer from the adapter and install into the mounting arm slot.
      • Thread on the adapter with the washer on the opposite side flush against the bolt head.
      • Torque to no more than 1.6Nm/14inlbs using a Hex wrench.
      • Apply a small amount of Blue LOCTITE® #242 to the threads of the adapter bolt if needed to keep it from coming loose.

      Carbon Fiber Stem Mount

      • Replace the stem’s screws (the bottom left and right), by inserting the spacer first, then the mount, washer and finally the long black Titanium screws.
      • Don’t use excessive force it may break the product and void the warranty.
      • Tighten the screws using the torque suggested by your stem manufacturer approx. 2 to 3Nm and lube the bolt with anti-seize grease.
      • Check holes for alignment between front clamp & stem. If there is an alignment mismatch top to bottom, the screw can undergo abnormal stresses and could break.
      • Before tightening make sure that the titanium screw penetrates the stem with full thread engagement. If screws don’t fully engage, please contact us.

      You may also like