Carbon Blade Series

Filter
      The Carbon Fiber Stem Mount
      Quick view
      Carbon Fiber Stem Mount
      $120.00
      Carbon Fiber Stem Mount
      Carbon Fiber Stem Mount
      Carbon Fiber Stem Mount
      Carbon Fiber Stem Mount
      Carbon Fiber Stem Mount
      Carbon Fiber Stem Mount
      Carbon Fiber Stem Mount
      Carbon Fiber Stem Mount
      Carbon Fiber Stem Mount
      Carbon Fiber Stem Mount
      Carbon Fiber Stem Mount
      Carbon Fiber Stem Mount

      Carbon Fiber Stem Mount

      $120.00
      /
      Shipping calculated at checkout.

      Carbon Fiber Stem Mount

      The stem mount is intended to be used for Road and Gravel riding but not Freeride, All Mountain or other riding. It's made from 3K Twill carbon fiber plate, 7075-T6 aluminum and uses Titanium hardware. Made to mount to any stem with a bolt hole width of 21 to 36 mm.

      Choose from either a Garmin or Wahoo adapter

      The mount includes a Titanium bolt and nut with a nylon washer to mount a light or action camera like a GoPro.

      Works with GARMIN® EDGE 200, 500, 800, 1000, Touring series, and WAHOO® Elemnt Roam and Element Bolt series computers.

      Combo kit works with all GoPro® Hero Cameras, Action Cameras and Cycling lights.

      Instructions:

      Don’t apply excessive force when tightening, excessive force may break the product and void the warranty. 

      Stay under 5Nm of torque (or read the max tighten torque suggested on your stem). Lube the bolt with anti-seize grease

      Before tightening make sure the titanium bolt penetrates into the stem threaded part at least 6 - 7mm.

        Weights:
        Mount + Computer adapter and hardware=33.4 grams
        Mount + Camera/Light hardware=37.0 grams

        Designed, Engineered and Made in the U.S.A

        Instructions

        Mounting Arm

        • Mount onto the handle bar to the left or right of the stem and tighten with a 3mm Hex wrench.
        • Torque not to exceed 1.6Nm/14inlbs.

        Adapters

        • Remove the bolt and washer from the adapter and install into the mounting arm slot.
        • Thread on the adapter with the washer on the opposite side flush against the bolt head.
        • Torque to no more than 1.6Nm/14inlbs using a Hex wrench.
        • Apply a small amount of Blue LOCTITE® #242 to the threads of the adapter bolt if needed to keep it from coming loose.

        Carbon Fiber Stem Mount

        • Replace the stem’s screws (the bottom left and right), by inserting the spacer first, then the mount, washer and finally the long black Titanium screws.
        • Don’t use excessive force it may break the product and void the warranty.
        • Tighten the screws using the torque suggested by your stem manufacturer approx. 2 to 3Nm and lube the bolt with anti-seize grease.
        • Check holes for alignment between front clamp & stem. If there is an alignment mismatch top to bottom, the screw can undergo abnormal stresses and could break.
        • Before tightening make sure that the titanium screw penetrates the stem with full thread engagement. If screws don’t fully engage, please contact us.